2 hrs. installing the rear support channel to the rear spar and installing the piece to hold up the landing light wires.

Rear support channel cleco'ed into place.

And it's done!

Drilled out the rivets for installing the "wire holder."

Marked the holes, center punched it and drilled it out (smaller than the rivet so that I would use the chucking reamer bit to final size it).

And it's in!

NEXT SESSION:

1. Start the wiring after installing all the grommets and any necessary edge grommets (is that what it's called?).
2. Flip the wing over to prepare to install the bottom skins!