Got the new fuel flow sensor assembly from Torrance and it's now fully installed along with the new fuel pressure sensor.  I'll be testing it tomorrow morning and will hopefully fly if all is well: No leaks and proper readings.

New assembly with new FT-60.  Looks good!  I just had to slide on the firesleeve and clamp them.

Assembling the banjo connections with the crush washers is a bit tricky so I put some paper towel under them so if any washers fell I wouldn't lose them (a royal pain..).

No dropped washers!

Solder butt connectors in place and some heat shield under it to keep the heat away from components that may have some fuel in them.  There's a green wire that comes out of the sensor, but that is not used.

All in and tightened down.  Excited to try it tomorrow.