Did get the end caps for the tank testing, but not the tubing yet. We'll see how sealed these caps are when I pressurize the tank (just with a balloon!).
The two sizes needed are 4 and 6, which you can get here.
Wired up the outer landing light and it works! I confirmed that putting in the two loose plates with the screw and compression spring is a exercise in super-human dexterity. I actually couldn't do it for the outer light's left side screws. I'll either have to get an right-angled pliers or figure out how to make the whole light sub-assembly structure more put together before attempting to connect it the wing.
Put some edge grommet around the hole where the wire bundle re-enters.
Wired up the wing tip strobe/position light!
NEXT SESSIONS:
- Test right tank.
- Work on the left tank.
No comments:
Post a Comment