Subcribe to our RSS feeds Join Us on Facebook Follow us on Twitter Add to Circles

Categories

Thursday, November 1, 2018

Quick half hour evening up the two fiberglass sides of the dash.

It probably doesn't matter because I think the outer cover overlays this, but this side is narrower than...

... this side.  So when it's on the fuselage, this side hangs down lower (so it would be riveted lower too).  That bothered me, so I wanted to even it up.  At least so both sides are roughly equal in width.

This is my approximation to match the other side (I did measure, but it's not a consistent width at all, so I just measured in a few places and matched them).

I feel better now. ;-)

No comments:

Post a Comment