2 hrs. on the firewall.  Thanks to Kerry for helping yet again!!!  Helps to have moral (and mental and physical) support sometimes....

Loosening that nut on the wheel of the servo enables you remove the cable so you can install the servo.  Note that the nut assembly has a small part inside, so be careful when removing it.

I had to trim 1/4" off the bushings to allow for enough threads to be available on the other side.

Starter solenoid location.

Sorry for the blurry photo...  Best place for the master?  The TCU location would be better...  Hmmm...  I'd consider putting the solenoids under the battery box, but that area I think will be busy with fuel lines and other cables.

Garage door open and fresh air in! 😁