Hmm, holes don't match up... The channel's holes are closer together than the firewall and...
...the plate on the other side. Question into the factory on this.
This support channel (not mentioned in the manual) goes here. It does overlap the reinforcing piece above it so...
...I cut out a notch.
Cleco'ed up and ready to rivet.
Test fit of the engine mount, which while tight, fit.
Except for the top channel (see the question above), it's all riveted. The mounting strips around the edge does not get done until the skins get put on.
Inside view of the bottom.
Full view of the inside.
No comments:
Post a Comment