Time to make the hole for the BNC connector of the antenna. Drilled it first then used the grinder on the Dremel to take it to size.
Done!
Need to ream out the latch attachment holes to M4 rivnut size.
As you'll see in the next photo I found that the holes in the latch itself were wider apart then the seat's holes and the holes in the thick piece seen here. I reamed the holes in the seat such that they were wider apart and also made the holes wider apart in the thick piece with a small reamer bit. The arrow is pointing to the parts (basically all of those parts I'm holding) that will actually go outside the upholstery.
Here you can see the pitch difference.
And it fits! Even though the upholstery will be under those parts, for now I will leave them like this so they don't get lost.
Done for the day and the work area all cleaned up!
No comments:
Post a Comment