3 hrs. on the firewall.

Finding the right size terminals for the starter contactor case ground wire.

Squeezing until the stripes line up with the yellow dot (for the yellow terminal).

Done....

And in place.  I ended up changing the edge grommet shown here to be a longer piece later on.

Wire to the 22,000uF cap.  Notice that I "clocked" the terminals to fit without twisting.

When I installed the all the terminals on a post, Deoxit'ed it and tightened it down, I put on torque seal.

Cap ground wire on.

Master switch wired up...

Limited space for tightening in this case...

Getting there...